Nizo 6080 Replacement Belt

Forum covering all aspects of small gauge cinematography! This is the main discussion forum.

Moderator: Andreas Wideroe

Post Reply
Gabe Agoado
Posts: 23
Joined: Wed Nov 11, 2015 12:34 am
Real name: Gabe Agoado

Nizo 6080 Replacement Belt

Post by Gabe Agoado » Sun May 22, 2016 12:24 am

I was told by the guys at Du-All that I needed to replace the belt in my Nizo 6080 in order to get the motor running (electronics are working fine) so I took it apart until I could remove the belt. The belt is fine, but there's a little slack in the system when I turned the motor with my hand. Could it be that the belt is slightly stretched which is what is preventing the motor from catching?

Post Reply