Film exposed at the beginning of the reel?

Forum covering all aspects of small gauge cinematography! This is the main discussion forum.

Moderator: Andreas Wideroe

Post Reply
Jessie
Posts: 2
Joined: Sun Aug 21, 2016 12:06 am
Real name: Jessie Noel

Film exposed at the beginning of the reel?

Post by Jessie » Tue Aug 30, 2016 12:31 am

Hi! I bought a Kodak cartridge and I was wondering...
When I put the cartridge in, since there's already a little lenght of film that is visible at the beginning of the reel and that therefore, that part of the film might be exposed... Should I shoot for a few seconds before actually filming what I have to film (to make sure it comes out the way I want it to)?
If so, how many seconds approximately?
Thank you!

richard p. t.
Senior member
Posts: 1002
Joined: Sat Oct 15, 2005 3:44 pm
Location: victoria, Australia

Re: Film exposed at the beginning of the reel?

Post by richard p. t. » Tue Aug 30, 2016 2:09 am

At 18 fps you would need to shoot for 0.16 seconds to get past the 3 frames that are already exposed. There are about five frames in total that are exposed, but the first lets say two frames are already past the center of the film window so no need to count them!
In short, no, you don't need to worry about that bit of film
Cheers
Richard
I run Nano Lab - Australia's super8 ektachrome processing service
- visit nanolab.com.au
richard@nanolab.com.au

Post Reply