What kind of resistors do I need to use in this Canon remote switch, if it is possible at all with the P2N2222A transist

Technical talk about 8mm, Super8, 9.5mm, 16mm and 35mm ++ motion picture cameras.

Moderator: Andreas Wideroe

Post Reply
Posts: 1
Joined: Tue Dec 26, 2017 3:37 am
Real name: kuanguang

What kind of resistors do I need to use in this Canon remote switch, if it is possible at all with the P2N2222A transist

Post by kuangang » Tue Dec 26, 2017 4:05 am

Hello,this part is talk adout camera, right? But I'm not sure my topic if suit, thank you. :-\ The backgroung for question: I'm a total electronics n00b set out to create an intervalometer for my Canon EOS 350D camera which seemed super simple from the outset, but I got a bit blocked with creating a switch using a transistor.

I don't fully understand the inner workings of the transistor and got lost with things like having to saturate it, using a shorting resistor, calculating voltage / current / resistance, etc to get the whole thing to act as a binary switch.

The camera circuit I want to switch is super simple and low powered (each switch carries about 0.5 mA at 3.3 volts):
(Source: http://www.covingtoninnovations.com/dsl ... lease.html )

For now I only want to get the expose bit working as it seems I'll only need to duplicate that for focus.

For the controlling circuit I want to use an IOIO board, which is very similar to an Arduino being a programmable controller with a variety of I/O pins to interface with whatever you throw at it.

I have a bunch of P2N2222A transistors which even with my limited knowledge seem to be usable for this purpose and a resistor kit with 20 values, but I'm not really sure how to combine them or if I need to get diodes too to get this working.

So far I tried connecting the Canon circuit to the Collector and Emitter legs of the transistor and then connecting to the Base the 5V pin from a battery through a 2.2K resistor (which the transistor came with) hoping that it will just work, but nothing happened :) At the moment I'm trying to get it working without the IOIO just to simplify things and to not fry it if I do something wrong :)

I got the idea from this diagram by the way:
( Source: http://www.mayothi.com/transistors.html )

It seems strange to me though that the controlling circuit is not really a circuit just a one way thing, and reading about shorting resistors on other pages I guess I'd need to connect the grounds together somehow and use a higher resistance resistor in it? Or maybe even a diode?
Thanks all!

Post Reply