Forum covering all aspects of small gauge cinematography! This is the main discussion forum.
Moderator: Andreas Wideroe
- Posts: 614
- Joined: Wed May 21, 2003 6:01 am
Anyone have a power cord for this projector they could see or know the pinouts of the three pronged connection?
- Posts: 656
- Joined: Fri Apr 15, 2011 2:07 am
- Real name: slashmaster
Is it a round socket? If not I would think the one in the middle is ground and the 2 on each side are just normal ac from the wall. By the way, I heard Heurtier is really nice! I read they have gates sprung from the back instead of the front. Is that true?
- Posts: 11
- Joined: Fri May 30, 2014 10:23 am
- Real name: Andre
- Location: Brittany
The P6-24 Heurtier power cable connector was a special "flat" 3 wired.
The middle pin was for the ground; right and left, for the power. You'll see if you open the projector.