Cannon Scoopic

Post by Pj » Fri Aug 19, 2005 4:54 pm

I dont know if it's been discussed but can the Cannon scoopic 16mm camera be converted to Super 16?

Pj

Post by **Evan Kubota** » Fri Aug 19, 2005 5:16 pm

I think I read no, because the fixed lens is too difficult to move. Not sure though.

Post by **gianni1** » Fri Aug 19, 2005 5:46 pm

I asked this a while back. Yes/No is the answer...

viewtopic.php?t=9473&highlight=scoopic+super+conversion

No if you cannot afford... Yes if you can afford a new super 16 Ikonsskop camera http://www.ikonoskop.com/acam/index.asp

Gianni

Post by **rollemfilm** » Sun Aug 21, 2005 9:03 pm

You can however design a hard matt using the behind the lens filter.
Although this may not be super 16, you can control the aspect ratio somewhat.

Post by **rollemfilm** » Sun Aug 21, 2005 9:04 pm

You can however design a hard matt using the behind the lens filter.
Although this may not be super 16, you can control the aspect ratio somewhat.