vicky the viking wrote:oh hi, good points!
gonna be shooting 200t (on this occasion) with a straight transfer to digibeta - delivered on digibeta.
a camera with good slow motion would be useful.
i guess you're right about the advantage of an external light meter....
some of the work might need quick decisions... i imagine (using automatic exposure) would be good to set the exposure on someone's face and then lock it there for that shot...?
Thanks,
Vicky
I think that 200T is a very good choice because it gives you so much flexibility in your transfer and in your exposure.
What I often do (most of my stuff is shot 'of the hip') when shooting outside is take an incident reading and then make judgements from that.
Of course if you are able to get up close you could take a reflected reading from someones face and expose for that (or you could use a spot meter) Generally, unless the light is very changeable you should be able to just take your reading and leave it there. If you have the camera on auto there can be a tendency for the aperture to be affected by irrelevant light sources or shadow, this could result in over/under exposure of your subjects and worse create a visible darkening/lightening of the whole frame - a la camcorder.
I would be inclined to overexpose the 200T slightly - outside and with the 85 filter it has an EI of 125ASA, so you could err on the side of over exposure and set your meter to 100ASA.
If you end up using a Beaulieu 4008 an important point to note is that the internal 85 filter is engaged/disengaged with a small lever inside the film compartment. The Vision2 200T cartridges do not have the requisite notch and so disengage the 85 filter when you insert them: Solution: use a sharp knife and cut your own notch or use a screw on filter on the lens.
Hope this helps.
Where are based?