Hanimex Projector Problems

Post by **BolexPlusX** » Fri Apr 14, 2006 5:03 am

Wild Guess:

It doesn't absolutely have to be electrical. How about thermal?

If the bulb is meant to operate with a stream of cooling air and it's not getting it maybe the bulb is overheating even at normal power.

Does this projector have a fan in it? If so is it spinning? If so is the air getting to the bulb?

Post by **Angus** » Fri Apr 14, 2006 9:28 am

Can you check the resistance of the bulbs?

If your meter can measure resistance (any multimeter should), you can check the reisistance between the two contacts...should be very low...