Filmshooting

Very nice! Can't wait for part two!!

Hi John!
I would like to test one - does Andec do 8mm ecn processing?

Yes, I can make a little howto on disassembling the cam, but it will take a couple days.
I will have to disassemble the cam againg for the actual repairs, I will make more photos then.

- Rodolfo

To "thereifixedit", if you have photos of what you have done to repair the camera, I would like to use ...

I have the canon 814XL [the one that is black and doesn't have 24fps] and I have the same issue when I press the trigger the camera runs, but when I release the trigger to stop the camera carries on until I tap it or take the batteries out. I'm told it's a common thing with these cameras, where a ...

http://www.nakanocam.com/8mm.html

Check that the contacts for the batteries are in mint condition, without any corrosion. You can clean them with a piece of light sandpaper with a pencil or pen

Yes I already did that (I cleaned the zoom contacts too), but my problem is that the camera never ...

Hi all!
I have recently acquired a Canon 814xl (the silent one) in seemingly good condition. The problem is that once I press the release button the camera does not stop and runs continuously, in both R and RL!
Is there some dial to set (other than RL) that can cause this?

Out of desperation, I ...